lashmatrix.orgShapesStylesLearnFAQAboutJoin

Close-Set Eyes · Wispy · Hybrid

The wispy lash map for close-set eyes, built in Hybrid — zone order, where the length peaks, and the point this one usually goes wrong.

An almond lid, the reference photo these two spacing shapes share. The spacing that defines them is in the diagram, not this photograph.
The lid itself reads almond — that part is not what makes this shape. What defines it is the distance between the two eyes, which no single-eye photograph can show. The diagram below does. Photo source & removal
Close-set is a gap, not a lid shape the gap one eye width the gap is narrower than one eye length goes outward lashmatrix.org/maps/closeset-wispy-hybrid
Eye spacing measured against one eye width — the thing that makes this shape.
PEAK inner outer peak high, then eases to the tail soft base + wispy spikes lifted above lashmatrix.org/maps/closeset-wispy-hybrid
Where the peak sits and which way the length tapers.
  • ShapeClose-set — a short gap at the bridge, so the loud work stays outboard.
  • EffectWispy done the usual way: closed-fan spikes over a base of singles and fans.
  • Where everyone strugglesDon't add a spike near the nose for symmetry. It is the loudest error here.
Why Why it is laid out this way

This is the usual way a wispy set is built: closed fans standing above a mixed base of singles and soft fans. Because a closed fan can be tall without being thick, the spikes reach further than a classic set's would, which lets the outer third carry more of the interest. The inner half still gets nothing that stands out from the line.

Zone order · bar = relative length Z1 Z2 Z3 Z4 Z5 Z6 PEAK Z7 inner outer lashmatrix.org/maps/closeset-wispy-hybrid
Build order, inner to outer — the peak zone flagged.

The order the zones go on, and where the fans land

  1. Plain short inner baseSingles across the first two zones, shortest on the lid, no fans and nothing tall.
  2. Mix the base from mid-lidFrom the third zone, fill between the singles with soft fans sitting just under their length.
  3. Spike the outer thirdClosed fans standing above the base, all past the outer iris, tucked into the line rather than perched on top of it.
  4. Group them, don't space themLet the spikes fall in loose groups with irregular gaps. Grouping is what makes them look like her own lashes.
  5. Hold the base to the cornerKeep filling to the tail so there is body underneath the spikes at the outer edge.
Length curve · one peak, gentle taper inner outer lashmatrix.org/maps/closeset-wispy-hybrid
The length curve: one soft peak, then a gentle taper.

The length curve on close-set eyes

The base runs the outward-shifted curve — short at the nose, peak in the outer third, tail carried — and the spikes concentrate attention on top of it. Two signals in the same direction make this one of the stronger corrections available on this spacing, provided the spikes land where they should. A single spike on the inner half sends the opposite signal, and it is louder than anything else on the eye.

Where does a wispy map go wrong on close-set eyes?

Every spike cut to the same heightEqual heights read as a fringe, and a fringe has no scatter in it. The outer third looks like a strip rather than like lashes.
✗ WRONG one height, reads flat ✓ RIGHT mixed heights scatter lashmatrix.org/maps/closeset-wispy-hybrid
Base left flat under the spikesAll the attention goes into the texture and the length curve underneath is forgotten. The spikes then sit on a line that corrects nothing.
✗ WRONG flat base, no shift ✓ RIGHT base carries the curve lashmatrix.org/maps/closeset-wispy-hybrid
One spike added at the inner cornerIt looks balanced in a photo of one eye and gathers the pair in every photo of her face. The brightest point ends up nearest the nose.
✗ WRONG one wisp by the nose ✓ RIGHT nothing tall inboard lashmatrix.org/maps/closeset-wispy-hybrid
When not to use this mapNot for a client whose outer third is weak — a closed fan is still the heaviest object on the map and there is nowhere else to put it. And when the spacing is very close, keep the spike count low, because each extra one is another statement about where her eyes appear to sit.
Deep The physics underneath

A closed fan is a spike you can weigh. That is the whole difference from the classic build, and it decides how far the outer third can be pushed.

The same map, built four ways

Classic 1:1
Singles keep the base readable and hold the length curve under the texture. They are also the honest choice for a spike when the natural lash beneath is strong enough to take one.
Handmade volume
Closing a fan down to a point gives a spike whose weight you chose, made of fine strands instead of one thick one. That control is why this is the standard way to build wispy.
Promade / pre-made fans
Quick and even for the base fill through the middle zones. Used as spikes they arrive at a fixed weight, which removes the one adjustment this map needs most at the corner.
Woven / clover
A wide repeating unit is the opposite of a scatter. Its place, if it has one, is low in the base where the line only needs to be present.

Spread angle versus weight

Spread moves mass — never removes it narrowload on the axis widetwists off-axis lashmatrix.org/maps/closeset-wispy-hybrid

A closed fan carries all its strands along one line, so it behaves like a single thick strand and should be budgeted as one. The open fans in the base want the least width that meets their neighbours: width there closes the gaps between spikes, and those gaps are what make the set read wispy instead of solid.

What a close-set lash line can carry

  • The outer third holds the base peak, the densest fill and every spike on the set at once. Whatever the weakest lash out there can hold is the real ceiling for the whole effect.
  • A closed fan weighs what its strands weigh, and it sits at the longest length on the map. Being able to make it fine is what buys the height — it does not make the height free.
  • Spikes are chosen lash by lash, never zone by zone. Pick the lash first and the spike second, and skip the spot altogether if nothing there will hold one.

Where this map fails first

Where this map fails first inner outer spikes lean out of line base loses body lashmatrix.org/maps/closeset-wispy-hybrid

Spikes turn before anything sheds, and a turned closed fan is instantly readable as a stray hair. The base under them thins at the same time, so the gaps that used to look like texture start looking like fallout. Both of those live in the outer third, which means this map ages in exactly the zone it exists to emphasise. Fills that replace spikes and top up the outer base are what keep it looking deliberate.

FAQ Common questions

What makes a hybrid spike different from a classic one?

It is a fan closed down to a point, so its weight is your choice. That lets a spike stand taller for less load than a single strand of the same length would put on the lash.

Where do the spikes go on close-set eyes?

Outboard of the outer iris and nowhere else. Spikes are the loudest thing on the set, and the inner half is the one stretch of lid that has to stay quiet.

Should the spikes be evenly spread out?

No — group them loosely with irregular gaps. Regular spacing reads as a strip and walks the eye along the lid instead of out past the corner.

Does the base still need the outward shift if there are spikes?

Yes, and it does most of the work. The spikes point at where the base already peaks, so a flat base leaves them decorating nothing.

Take it with you

Print this page or save it as PDF — the diagrams are drawn to stay readable in black and white on plain paper. Or download the diagrams below as SVG. No account, no fee, nothing to sign. Every file carries this page’s address, so wherever it ends up it can be traced back here.

Teaching from these? The offer, and how to credit it.

Also in: Close-Set eyes · Wispy · Hybrid

Read next: what makes a lash map wispy rather than spiky · questions clients ask about lash extensions